Collect sticks and fallen branches from your garden and local parks or pick up driftwood from beaches and turn them into charming little additions to your garden.

WATCH: Melissa shows you how!

Now get your step-by-step guide

You can’t take anything out of national parks. Fallen branches become habitat for the creatures that live there. 

Help your climbers and twiners up the wall with this cute, rustic-looking ladder.

Tape measure; pruning saw; 60-80 grit sandpaper; scissors

Measure height you want ladder to be.

Decide on space between rungs and determine number of rungs you need, including one at the top for hanging.

Cut sticks with pruning saw so they are roughly of equal length, about 30cm. They don’t need to be the exact same length.

Sand ends to rounded points.

Cut 2 lengths of rope to the height you want, adding about 15cm for each rung knot.

Temporarily tie one end of each rope to garden bench, tree or something that is secure. (Image 44)

Tie each rung with marlin spike hitch (see below).

How to make a marlin spike hitch - Step 1

Screw brackets into wall, release ladder from tether and hang top rung on brackets.

Put potted climber such as jasmine at base of ladder to discourage children from climbing it, and train plant up the rungs.

Orchids love rocks, crevices, a tree trunk’s corner. Make these exquisite plants feel at home in this hanger made of twigs.

Pruning saw; 60-80 grit sandpaper; timber saw; white-out paint; marker; drill; 2mm drill bit; wire cutters; scissors

Cut sticks with pruning saw into 10 roughly equal-sized pieces about 20-25cm long. Sand ends into rounded point.

In a trial run, place two sticks on flat surface. Put two sticks on top in opposite direction and repeat until you have five layers.

Make sure your orchid fits in the space.

Cut paling piece with timber saw to length that matches joining points, plus a few centimetres. Mark on the piece where the drill points should be with white-out paint. Use this as a spacer to ensure drill holes match at end of all sticks.

Put spacer on each stick and mark drill points.

Drill holes through each stick.

Cut 4 pieces of wire, each about 80cm long. Bend one end of each piece to 90 degree angle at about 20-30cm point. Put short end of wires on flat surface and rebuild basket by threading top two sticks through wires, and repeat for next four layers.

On top of fourth layer place spacer across the middle. This will serve as the base of the basket. 

Thread final, fifth layer of sticks through wire and wind wire around and across corners to secure basket.

Turn basket over and twist 4 ends of wire into nooses wider than 2 pieces of rope. Trim away excess wire.

Cut 4 pieces of rope to double the length you want basket to hang, plus extra centimetres for knots.

Thread rope through 4 loops and create single knots just above loops (see below).

Cut hessian to fit base of basket and insert.

Soak sphagnum moss and wring out excess water. Create basket lining about 5cm thick.

Remove orchid from pot and insert with its original mix into basket.

Join the 8 pieces of rope with double knot (see below), trim ends with scissors and hang.

Single and double knots • For the single knot, double twine over so ends meet. Pass folded end through wire nooses (step 10) and draw through so fold meets 2 ends. Cross folded end over double length of twine to create loop. Pass folded end through loop and tighten • For double knot, pass twine through loop again and tighten.

Most orchids are epiphytes and draw their water and nutrients from the air around them so don’t need soil to thrive. This hanging basket with its open arrangement means you don’t need to worry about soil falling though the gaps. Keep the sphagnum moss moist.

Make your basics stupendous by stylising your beans, peas or tomatoes around this bespoke tepee, or make a feature in your ornamental garden for climbing, flowering plants. It creates a natural elegance.

Pruning saw; secateurs; garden fork; hammer; scissors

Cut branches into stakes about 2m long

Turn soil over to aerate.

Hammer in stakes so they all meet at the top. 

Tie stakes together at top with rope and secure with double knot (see above for instructions). Cut ends of rope with scissors.

Wrap stakes with rope at 30cm points, starting at the bottom, and tying with single knots (see above for instructions).

Plant your chosen climbers in soil underneath.

For more gardening projects, pick up a copy of the latest issue of Better Homes and Gardens magazine in selected newsagents and supermarkets or buy online today!

How to make a stacked herb tower

How to make beautiful flower pots at home

Melissa makes terrariums for kids

Plus, your chance to win

Plus, your chance to win

Treat yourself to a subscription-Save up to 25%